Brand New Genuine factory/OEM  GM Keyless entry key fob remote for your 2008, 2009 or 2010 Buick Enclave.  If you have lost your original key fobs, or simply need replacment fobs,  this is the part you need!  These fobs must be programmed to your vehicle. Programming is easy, and instructions can be found in your owners manual (but are also included below)  Please remember that your vehicle must already have a factory installed keyless entry system for this  keyless remote to work. If you have an aftermarket keyless entry system, or if your car did not come equipped with the keyless entry option, this key fob will not work for you.  

This item replaces GM part numbers: 

20859053 15857839 15913415 20952477

Need help? Our helpful customer service representatives can be reached 24/7 via email. Simply click the "contact us" link on the menu above. 

Programming Instructions

Use this Procedure for Vehicles with
Driver Information Center Buttons

This information is in your Owners Manual in the
Drivers Information Center Section.
1. Insert Key and turn to ON position so you can access Driver Information Center
2. Press the vehicle information button until
PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until
REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the keyless remote at the same
time for approximatley 15 seconds. A chime will sound indicating that the remote is
programmed.
5. To program additional remotes at this time repeat step 4.
This vehicle can have a maximum of eight remotes programmed.
6. To exit programming mode turn key o and remove key.
Test remote(s).

Use this Procedure for Vehicles without
Drivers Information Center Buttons

To access this display, the vehicle must be in Park (P) with key in the on position (as far
as you can go without cranking engine)
1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds.
The message REMOTE KEY LEARNING ACTIVE will display
3. Press and hold the lock and unlock buttons on the rst keyless remote at the same
time for approximately 15 seconds. A chime will sound indicating that the remote is
programmed.
4. To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key o and remove key.
Test remote(s).