Brand New Genuine factory/OEM  Ford Keyless entry key fob for your  1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 or 2012  Ford Taurus.  If you have lost your original key fobs, or simply need replacment fobs, 

Brand New Genuine factory/OEM  Ford Keyless entry key fob remote.  If you have lost your original key fobs, or simply need replacment fobs,  this is the part you need!  These fobs must be programmed to your vehicle. Programming is easy, and instructions can be found in your owners manual.       Please remember that your vehicle must already have a factory installed keyless entry system for this  keyless remote to work. If you have an aftermarket keyless entry system, or if your car did not come equipped with the keyless entry option, this key fob will not work for you.  

Replacement part numbers: CWTWBU331, CWTWB1U345, CWTWB1U322, GQ43VT11T, 2S4T-15K601-AB

Need help? Our helpful customer service representatives can be reached 24/7 via email. Simply click the "contact us" link on the menu above. 

Programming Instructions:

FORD REMOTE – THIS PROCEDURE RESETS ALL REMOTES FOR THE VEHICLE.  ALL FUNCTIONING REMOTES WILL HAVE TO BE REPROGRAMMED DURING THE PROCEDURE

There are a few different procedures that will program your remotes depending on what vehicle that you have. You can find your exact procedure in your owners manual. If you do not have your owners manual you can try any of the procedures below until you find the one that works for your vehicles

Make sure that you don’t press the brake pedal at any time during or before the procedure.

Procedure A:

1.Close all doors, then open drivers door and press the Unlock button on driver’s door while it is open, insert key into ignition.
2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (if the door locks do not cycle, then it  was done incorrectly. You must start over by removing key and beginning  from step 1)

(Off is the position where you can remove your key, RUN is the position just shy of starting your car.)

3.Within 10 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 5.
4.Within 10 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 4. for all other remotes.
5.Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

Procedure B:
1. Turn the ignition from OFF to RUN 4 times within 3 seconds.
2. Turn the ignition OFF. The system will chime to confirm programming mode.
3. Within 10 seconds, press any button on first keyless remote. The system will chime once to confirm programming.
4. Within 10 seconds, press any button on second keyless remote. System will chime once to confirm programming.
5. Turn ignition to RUN to exit programming mode.

Please note: All steps should be performed in fairly rapid succession. If you never get the initial chime or door lock cycle, that means the vehicle has never entered programming mode. You should remove key from ignition, open and close the door and start over.